The Modfountain Basin Kit is the perfect solution for installing any X Series, LX Series or Wave Modfountain.

Kit includes:

• BASIN. 48” dia. x 16” deep (overall Dia. 51.5”) High-Density Polyethylene with removable grates and submersible pump access panel. 95 gallon capacity. Supports 1200 lbs. (overkill) and weighs a mere 60 lbs. allowing for easy transport and installation.

• Illumiflow Submersible PUMP. 2100 gph (gallons per hour). Water cooled - no oil, thermal overload protection, 24 month Warranty. The pump assembly also comes with a kink-free tube with easy disconnects and standpipe with control flow valve.

• Fountain Basin AUTO-FILL. Never worry about water levels again. Includes float valve, and hardware, it even includes plumbers tape. Easy attachment to your water source garden hose or permanent water pipe.

• Splash APRON. This 76” square splash apron will help to prevent water loss from your fountain by extending beyond the perimeter of your basin, capturing and returning water that would other wise end up in the surrounding landscape. The apron is deliberately left uncut for you to custom cut the apron to fit around your fountain(s) and trim any additional material that is unnecessary.

• Stainless Steel CABLE TIES. Set of (4) 19” cable ties. Easy to thread through fountain’s anchor holes and basin grates for a secure attachment in severe wind conditions. Each cable tie supports 270 lbs., 4 ties securely supports an overkill weight of 1080 lbs.

Check with your local garden/landscape supply for decorative rocks and plants to put the finishing touch on your fountain’s installation.